SMR Gearbox Installation
Satisfactory overall performance is determined by suitable set up. lubrication and servicing. as a result it is vital that the instructions while in the set up and upkeep leaflet. supplied with each gearbox. are followed carefully. some of the important facets of belt and torque-arm set up are listed below.
1. Install pulley on gearbox input shaft as shut to your reducer feasible, and mount reducer on driven shaft as close to bearing as practical. failure to carry out this may cause extra loads while in the input shaft bearings and output bearings and could trigger their premature failure.
two. Install motor and wedge belt drive using the belt pull at approximately 90° to the center line in between driven and input shafts. this may permit tensioning of the wedge belt drive together with the torque arm which should really preferably be in stress. if output hub runs anti-clockwise. torque arm really should be positioned the correct.
three. lnstall torque-arm fulcrum on a rigid help so that the torque-arm will likely be at approximately right angles to your center line through the driven shaft and also the torque arm situation bolt. ensure there exists enough consider up during the turnbuckle for belt tension adjustment.
Maintain near.
Bell drive can be found in any handy postion. should the torque arm is usually to be applied to tighten the belts, the drive needs to be at about tight angle for the line concerning the input and output shafts.
Bell drive may be found for the proper if preferred.
If output hub rotates clock-wise. position belt drive and torque arm in opposite path to that shown in the illustration.
Torque arm and belt take up.
Torque arm can be mounted towards the right if preferred.