As a technician of the cycloidal pinwheel reducer, you must not only have a wealth of knowledge and a lot of experience in the reasonable purchase of cycloidal pinwheel reducers, but also need to have some common faults and uncommon problems of the cycloid pinwheel reducer. The ability to deal with difficult problems.Only by mastering these is a qualified reducer technician.Regarding the purchase of reducer, I will not discuss it in depth, but this is not an aspect that can be ignored.And another aspect of the reducer technology is that after the reducer is purchased, it is often used, or overused, or even used in a small amount, there will be some problems, and these problems are not only about the theoretical knowledge of the technician. A practical assessment is also to examine the ability of the reducer technician to respond to some unexpected problems.The following will explain in detail some common problems of the reducer.
For an important member of the cycloidal pinwheel reducer family---cycloid pinwheel reducer, it sometimes has such a problem that its temperature may be too high, and too high temperature will cause many problems, not only Affect its efficiency, and even damage the reducer in severe cases.This is a problem that needs everyone to pay attention to. For its high temperature, we can first analyze it from theory, then draw a conclusion, and finally give a solution. This is a common route to deal with emergency problems.
If the cycloidal pinwheel reducer heats up during use and the temperature is too high, generally speaking, this may be a problem with the eccentric bearing and a malfunction.Of course, this is only a general situation, and other factors should also be considered. For example, if the machine is newly purchased, there may be unreasonable parts in the assembly, or there may be problems.Of course, this knowledge is the first reflection in the mind after discovering the temperature fault of the reducer, but this does not mean that the problem is due to this reason.For the temperature problem of the cycloid reducer, there may be another important factor that needs to be considered, that is, the problem of lubricating oil. If the reducer lacks lubricating oil, it may also cause the above problems.This needs to prescribe the right medicine and adapt the measures to local conditions.
Of course, there are some other reasons that need to be considered. If the cycloid reducer is often overloaded, the temperature may be too high. However, these factors need to be analyzed and eliminated to find the most correct answer.The reason why the temperature of the cycloid reducer is too high has been found, and then there are solutions. There are many solutions to things, but the most straightforward and simplest, and the most reasonable, should be the best method, which belongs to deceleration. The basic theory of machine technology will not be stated too much here.
In short, for the problem of excessive temperature in the cycloid reducer, first find out its reasons, such as the above-mentioned possibilities. If these reasons are eliminated, then look for other factors that may affect the temperature of the reducer. Factors, then prescribe the right medicine, give a solution, and implement it.Doing this will make it easier to deal with the failure of the reducer.